• This Self-Adhesive Vinyl use the white glue. and the performation
of coverage is well.
• The surface film has the good performance of the ink obsorbing,
can be applied to a wide range of inkjet printers.
• Use the removable glue, to ensure the cleanliness of the bottom
paper and facilitate to the second use
used for the wide format digital printing indoor and outdoor, the
eco solvent printing and screen printing, mainly used in
advertising of the windows of the buses, taxis, subway and other
means of transport, glass wall advertising, windows of shopping
Large-format vehicle pasters/advertisement stickers are widely
Dry paste method
The procedures and tools:clean rags, flake flattener
•Clean the vehicle and keep it dry.
•Strip off the transfer film (the transparent film which is pasted
on the vehicle paster) and the vehicle paster together; in general
situations, please simultaneously paste the sticker, flatten and
stripping the release paper.
•If the length and width of pasting area are less than 10
centimeters, you can paste after stripping off the transparent
transfer film and sticker, but must pay attention on the unexpected
adhesion or dust due to falling down.
•Forcibly and obliquely flatten with a clean rag or flake flattener
for several times until the paster has no any bubbles, then remove
the transparent transfer film.
We suggest not to solarize or wash within 24 hours.
Wet pasting method:it is suitable for wrapping large vehicles (two-person working
together is recommended)
The procedures and tools:water sprayer, clean rag, flake flattener, snap-Off Knife, blow
• After the vehicle body is cleaned, spray water on the area you
paste with the paster by water sprayer– which is mainly used to
reduce viscosity of the paster, and facilitate the position
• Once the pasting position is confirmed, strip up the paster along
with the transfer film (the transparent film which is adhered on
the Reflective wrapper), from right to left (or top to bottom),
press and flatten them onto the vehicle body with rag, at the same
time, peel off the release paper.。
• Regarding to the handle or the bumper strip, cut off or enfold
the paster according to the circumstance.
• Timely adjust the position of the graphics, repeatedly scrape off
the bubbles and water with flake flattener from right to left in an
oblique way after the position of the graphics is confirmed, and
finally remove the transparent transfer film.
• Cut off when coming to the door and joint with snap-Off Knife,
and paste the paster inwards wherever possible.
• Dry the water underneath the paster as much as possible, and use
the blow dryer to heat moderately if the condition allows.
Suggestion:We suggest neither to solarize the vehicle within 24 hours, nor to
wash it within 48 hours as far as possible.